| 背部面板加工工艺 |
| 添加时间：2020/7/2 15:16:19 浏览次数： |
| 背部面板加工工艺 Processing technology of back panel 测量记录数据输入字段背面面板生产线电脑精确地控制加工后面板的长度和数量。背面板送料。将复试检验合格的热镀锌卷板装在进行开卷机上，启动背面板企业生产线，将热镀锌卷板送入一个生产线内；进入生产线的热镀锌卷由平辊自动压平；由计算机控制自动切断镀锌板的长度；经冲切后的镀锌板在生产线上按设计发展要求进行自动辊压成波浪形；选择专业喷塑进行喷塑。预处理，磷等喷雾之前，比76um多个塑料层厚度，塑料粉末必须是实用的纯聚酯材料。检查喷雾，贴于背面板的保护的塑料薄膜，传输层是避免刮伤喷雾处理；根据背面板，宽度，表面粗糙度和划痕的设计要求检查长度，满足所列数量的要求。 Measurement record data input field back panel production line computer accurately controls the length and quantity of processed back panel. Back panel feeding. Install the qualified hot-dip galvanized coil plate on the uncoiler, start the production line of the back panel enterprise, and send the hot-dip galvanized coil into a production line; the hot-dip galvanized coil entering the production line is automatically flattened by the flat roller; the length of the galvanized sheet is automatically cut off by computer control; the galvanized sheet after punching is automatically rolled into wave shape on the production line according to the design and development requirements Professional spray plastic spray. Pretreatment, phosphorus and other spray before, than 76um multiple plastic layer thickness, plastic powder must be practical pure polyester material. Check the sprayed plastic film on the back panel. The transmission layer is to avoid scratching spray treatment. According to the design requirements of the back panel, width, surface roughness and scratches, check the length to meet the requirements of the listed quantity. |
| 上一页 孔板吸声 |
| 下一页 声波在传播过程中遇到声屏障 |
Copyright © 技术支持：遨游网络